Olivetti P26W - Manual (Page 53)

Microsoft Windows> 53
1. Ensure that the TCP/IP protocol has been installed in
Windows. This can be confirmed by checking the network
settings from within the Control Panel. If TCP/IP has not
been installed refer to the section below Installation of
TCP/IP protocol.
2. If not already configured, a suitable IP address, Subnet
Mask and Gateway address should be configured. Please
refer to the on-line help if necessary. It is vital that the IP
address entered is unique and valid. Entering an incorrect
IP address may cause severe network problems. Please
check the address with the network administrator.
3. If your network environment uses domain names, DNS
should be enabled and configured on your system.
However, this step is not essential to enable network
printing.
4. Restart the operating system.
W INDOWS 2000
1. Click the [Start] button, select [Settings] and then click
on [Network and Dial-up Connections].
2. Double-click the [Local Area Connection] icon. In the
[Local Area Connection Status] dialogue box, click the
[Properties] button.
3. If the TCP/IP protocol is not listed, in the [Local Area
Connection Properties] dialogue box, click the [Install]
button.
4. In the [Select Network Component Type] dialogue box,
select [Protocol] and click the [Add] button.
5. In the [Select Network Protocol] dialogue box, select
[TCP/IP Protocol] and click the [OK] button.
6. Click the [Close] button in the [Local Area Connection
Properties] dialogue box.
7. Click the [Close] button in the [Local Area Connection
Status] dialogue box.
W INDOWS XP
1. Click the [Start] button and select [Control Panel].