O'Neil microFlash Series - Manual (Page 32)

22
•
Quick Demo User Manual and Technical Guide The O'Neil microFlash Series of Printers
Self Test
Push the red button and hold four seconds to print a self test. Below is an explanation
of the print-out.
Self Test Description Page
F/W Ver Internal software version Page 104
Timeout The seconds between printing and sleep mode. Page 29
Baud Rate The speed at which the microFlash receives data. Page 27, 28
Parity Odd, Even or None. Page 27, 28
Data Bits Matches that of computer sending data to microFlash. Page 27, 28
Handshake The way the printer handles flow control from host. Page 27, 28
Burn Adj Amount of heat used to print on the thermal paper. Page 20
Paper 1 or 2 ply. Page 30
Beeper May be turned ON or OFF. Page 29
Batt Volt Current voltage of the battery pack. Page 103
Batt Temp Temperature of battery. Page 103
Flash / RAM 1 M or 4 M Flash / 1 M or 4 M RAM Page 105
Boot Version Boot sector firmware. Page 104
Prnhd Tmp Between 0 and 50 degrees. Page 83
Comp Grph Either “Pause or Immediate”. If paused, and entire image is
received by printer before printing. Page 83
Infrared Set by the user to “Off” or “IrDA” or “ASK” or “ASK/CRC” or
“Direct” or “Direct-CRC” or “PULSE” or “PULSE-CRC” Page 31, 104
Device Name Shows type of device (microFlash2,3,2t,2tcr,2I,2icr,4t or 4tcr ) Page 31
Device Nickname Shows user name for printer. Page 31
IrDA Ver The 1.0 refers to the IrDA standard in use. The next two digits
refer to any IR modifications made by O’Neil. Page 31
Available Fonts “LOC,” shows whether a font is Resident (“R”) or Downloaded
(“D”). “CPI” shows characters per inch. “DESCRIPTION”
describes the font. “NAMES” gives the “Easy Print” name, the
Line Printer name, and the hexadecimal equivalent of that name. Page 32, 108
Available Graphics “LOC,” shows whether a font is Resident (“R”) or Downloaded
(“D”). “CPI” shows characters per inch. “DESCRIPTION”
describes the graphic. “NAMES” gives the “Easy Print” name,
the Line Printer name, and the hexadecimal equivalent of that
name. Page 34, 109
Available Barcodes All supported Barcodes supported are displayed.
“ESCRIPTION” describes the graphic. “NAMES” gives the
“Easy Print” name, the Line Printer name, and the hexadecimal
equivalent of that name. Page 69
Card Reader Option Shows the current Card Reader configuration. Page 73