O'Neil microFlash Series - Manual (Page 52)

42
•
Paper Loading User Manual and Technical Guide The O'Neil microFlash Series of Printers
Removing Paper Core
For the MF2/3 remove the round end boot of the printer by tucking the
tips of your fingers under the edge of the boot and pulling it off with a
peeling motion.
Wrap your index finger around the wider end of the paper rod and pull
up. The paper rod will snap out. Remove the empty paper core and
discard. (Save the plastic rod)
For the MF2t/2tCR/2i/2iCR/4t/4tCR Un-snap the latch and lift up the
cover. Wrap your index finger around the empty paper core and pull up.
The paper rod will snap out. Remove the empty paper core and discard.
Paper Loading
Standard Paper
If you are using standard paper, you can load the paper automatically or
manually. Experiment to find out which method is best for you.
Linerless Labels
If you are using linerless paper, it is recommend that you use the manual
paper loading method.
Automatic Paper Loading MF2/3
Press the red self test button to wake the printer. With the loose, clean
edge of the paper coming from the bottom of the roll, insert the edge of
the paper between the roller and the platen. If the printer is on, it will
feed the paper automatically. If you have allowed the printer to fall into
sleep mode, press the red self test button. Insert the plastic paper rod