O'Neil microFlash Series - Manual (Page 56)

46
•
Batteries User Manual and Technical Guide The O'Neil microFlash Series of Printers
microFlash3 Battery Power
To determine the current charge on the battery pack, you can print out a
self test by pressing and holding the red self-test button on the side of the
printer for four seconds. If the battery is good, you will see the word
“GOOD” next to the Battery voltage print out.
The microFlash3 printer has a built in low battery detector. When your
printer's battery voltage is low, the printer will beep three times,
indicating a Low Battery Warning.
The microFlash3 will charge in approximately four hours.
microFlash2t/2tcr/2i/2icr Battery Power
To determine the current charge on the battery pack, print out a self test
by pressing and holding the red self-test button for four seconds. If the
battery is good, you will see the abbreviation for the word “GOOD” next
to the Battery voltage print out.
The microFlash printer has a built in low battery detector. When the
printer's battery voltage is low, the printer will beep three times,
indicating a Low Battery Warning. This will only happen however, if the
printer is awake.
The microFlash2t/2tcr/2i/2icr is charged in approximately six to nine
hours.
microFlash4t/4tcr Battery Power
To determine the current charge on the battery pack, print out a self test
by pressing and holding the red self-test button for four seconds. If the
battery is good, you will see the abbreviation for the word “GOOD” next
to the Battery voltage print out. The 4t/4tcr can use two batteries
(VBATT1 and VBATT2).
The microFlash printer has a built in low battery detector. When the
printer's battery voltage is low, the printer will beep three times,
indicating a Low Battery Warning. This will only happen however, if the
printer is awake.
The microFlash4t/4tcr is charged in approximately three hours.
Charging the microFlash with the AC Adapter
1) Plug the AC adapter into a standard wall outlet.
2) Plug the other end into the DC jack on the side of the microFlash
printer. The battery charge light will glow red while the battery is