Duplicate scan delay, Continuous scan – Opticon LH2 User Manual
Page 85
Advertising
Continuous Scan
84
Continuous Scan
85
Command Name: Duplicate Scan Delay
Usage:
Sets the duplicate scan delay time in the continuous scan mode.
Description:
This command allows you to program the delay time between scans
while in continuous scan mode so that the imager will not read the
same bar code again.
Default:
Duplicate Scan Delay is set to 0 seconds
Programming Code:
Serial Command:
3 Seconds
P%d63<┘
Options:
Programming Code:
Serial Command:
1 Second
P%d61<┘
0 Second (Default)
P%d60<┘
Advertising