Opticon LH2 - Manual (Page 97)

96
Prefix / Suffix
97
Optimization Matrix
Command Name: Optimization Matrix
Usage: Sets the imager to read different sizes of barcodes.
Description: By setting a few parameters of the imager you can take advantage
of the dual path imager to read barcodes of different sizes. For your
convenience there are some preset standard settings created to read
different variety of barcodes. Look at the charts on the next page to
assess your environment.
More details are in Chapter 3, sub topic “4) Imager Field of
View & Resolution”.
Default: The B1 non continuos mode setting is the default.
Note: 1. The tables on the next page represents the settings for each cell.
2. On the following pages there are 2 sets of tables (4 tables
altogether).
3. The first set is the setting for single trigger and the second set is
for continuous trigger.
4. In each set one table has barcodes and the other table has the
corresponding serial commands. For example:
Barcode in cell A1 from SET 1 = Serial command in cell A1 from SET
1.
5. All the serial commands have a carriage return at the end of each
line.
6. If you use commands from SET 2 - “Continuous trigger“ then you
can turn OFF the continuous trigger by using the “Continuous Scan
OFF” command.