Onkyo AV RECEIVER TX-NR5009 User Manual

Page 35

Advertising
background image

35

En

Note

• You can cancel Audyssey MultEQ XT32 Room Correction and

Speaker Setup at any point in this procedure simply by
disconnecting the speaker setup microphone.

• Do not connect or disconnect any speakers during

Audyssey MultEQ XT32 Room Correction and Speaker Setup.

• If the AV receiver is muted, it will be unmuted automatically

when Audyssey MultEQ XT32 Room Correction and Speaker
Setup starts.

• Changes to the room after Audyssey MultEQ XT32 Room

Correction and Speaker Setup requires you run
Audyssey MultEQ XT32 Room Correction and Speaker Setup
again, as room EQ characteristics may have changed.

Error Messages

While Audyssey MultEQ

®

XT32 Room Correction and

Speaker Setup is in progress, one of the error messages
below may appear.

The options are:

`

Retry:

Try again.

`

Cancel:

Cancel Audyssey MultEQ XT32 Room Correction
and Speaker Setup.

• Ambient noise is too high.

The background noise is too loud. Remove the source of
the noise and try again.

• Speaker Matching Error!

The number of speakers detected was different from
that of the first measurement. Check the speaker
connection.

• Writing Error!

This message appears if saving fails. Try saving again.
If this message appears after 2 or 3 attempts, contact
your Onkyo dealer.

• Speaker Detect Error

This message appears if a speaker is not detected. “No
means that no speaker was detected.

Tip

• See “Speaker Configuration” for appropriate settings

(

page 13

).

Changing the Speaker Setup Manually

You can manually make changes to the settings found
during Audyssey MultEQ XT32 Room Correction and
Speaker Setup.
See also:
“Speaker Configuration” (

page 52

)

“Speaker Distance” (

page 53

)

“Level Calibration” (

page 54

)

“Equalizer Settings” (

page 54

)

Note

• Please note that THX recommends any THX main speakers be

set to “80Hz(THX)”. If you set up your speakers using
Audyssey MultEQ XT32 Room Correction and Speaker Setup,
please make sure manually that any THX speakers are set to
80Hz(THX)” crossover (

page 52

).

• Sometimes due to the electrical complexities of subwoofers and

the interaction with the room, THX recommends setting the
level and the distance of the subwoofer manually.

• Sometimes due to interaction with the room, you may notice

irregular results when setting the level and/or distance of the
main speakers. If this happens, THX recommends setting them
manually.

Using a Powered Subwoofer

If you’re using a powered subwoofer and it outputs very
low-frequency sound at a low volume level, it may not be
detected by Audyssey MultEQ XT32 Room Correction
and Speaker Setup.
If the “Subwoofer” appears on the “Review Speaker
Configuration
” screen as “No”, increase the subwoofer’s
volume to the half-way point, set it to its highest crossover
frequency, and then try running Audyssey MultEQ XT32
Room Correction and Speaker Setup again. Note that if
the volume is set too high and the sound distorts, detection
issues may occur, so use an appropriate volume level. If
the subwoofer has a low-pass filter switch, set it to Off or
Direct. Refer to your subwoofer’s instruction manual for
details.

Save
Cancel

AUDYSSEY

MultEQ XT32: Auto Setup

Ambient noise is too high.

Error message

Advertising