Onkyo AV RECEIVER TX-NR5009 - Manual (Page 57)

57
En
DTS
■
Neo:X Music
Center Image
`
0 to 2 to 5
The DTS Neo:X Music listening mode creates 9-channel
surround sound from 2-channel stereo sources. With this
setting, you can specify by how much the front left and
right channel output is attenuated in order to create the
center channel.
Changing the value from “0” to “5” will spread the sound
of the center channel to left and right (outwards).
Audyssey DSX™
■
Soundstage
` –3dB to Reference to +3dB
With this setting, you can adjust the sound stage when
using Audyssey DSX.
Note
• This listening mode can be selected only when all the following
conditions are satisfied:
– The center speaker is connected.
– The front high and front wide speakers are connected.
• The “Soundstage” setting cannot be adjusted while Speakers B
is selected.
Theater-Dimensional
■
Listening Angle
` Wide:
Select if the listening angle is greater than 30
degrees.
` Narrow:
Select if the listening angle is less than 30 degrees.
With this setting, you can optimize the Theater-
Dimensional listening mode by specifying the angle of the
front left and right speakers relative to the listening
position. Ideally, the front left and right speakers should
be equidistant from the listening position and at an angle
close to one of the two available settings.
LFE Level
■
Dolby Digital *1 , DTS *2 , Multich PCM, Dolby
TrueHD, DTS-HD Master Audio, DSD *3
` – dB, –20dB, –10dB, or 0dB
With these settings, you can set the level of the LFE (Low
Frequency Effects) channel individually for each input
sources.
If you find that low-frequency effects are too loud when
using one of these sources, change the setting to –20 dB or
–
dB.
*1 Dolby Digital and Dolby Digital Plus sources
*2 DTS and DTS-HD High Resolution sources
*3 DSD (Super Audio CD) sources
Direct
■
Analog
Subwoofer
`
Off:
Analog audio signals (bass signals) are not output.
`
On:
Analog audio signals (bass signals) are output.
This setting determines whether or not analog audio
signals (bass signals) are output from front speakers when
the Pure Audio or Direct listening mode is selected.
Note
• If the “Subwoofer” setting is set to “No” (
➔ page 52
), this
setting cannot be selected.
■ DSD
DAC Direct
`
Off:
DSD signals are processed by the DSP.
` On:
DSD signals are not processed by the DSP.
This setting determines whether or not DSD (Super Audio
CD) audio signals are passed through the DSP for A/V
Sync, delay, etc., processing when the Pure Audio or
Direct listening mode is selected.
Note
• Once you have selected “Yes”, only DAC Direct will be
available for selection. “DSD Direct” will appear on the display.
Front left speaker Front right speaker
Listening angle: 30°