Onkyo AV RECEIVER TX-NR5009 - Manual (Page 74)

74
En
Adjusting the Volume for Zones
■
Operating on the remote controller
■
Operating on the AV receiver
If your Zone 2/3 speakers are connected to a receiver or
integrated amp in Zone 2/3, use its volume control to
adjust the volume.
Muting Zones
■ Operating on the remote controller
Tip
• To unmute, press ZONE followed by MUTING again. Zones
can also be unmuted by adjusting the volume.
Adjusting the Tone and Balance of Zones
Note
• Only analog input sources are output by the ZONE 2/3
PRE/LINE OUT and FRONT WIDE/ZONE 2 L/R, SURR
BACK/ZONE 3 L/R terminals. Digital input sources are not
output. If no sound is heard when an input source is selected,
verify that the source is connected to an analog input.
• While Zone 2/3 is on, functions will not work.
• You cannot select different AM or FM radio stations for your
main room and Zone 2/3. The same AM/FM radio station will be
heard in each room. Namely, if you have selected an FM station
for the main room, that station will also be output in Zone 2/3.
• When you have selected NET or USB as the input selector, the
last selector selected will be set for Main room, Zone 2, and
Zone 3.
• When Zone 2/3 is activated and its input selector is selected, the
power consumption of standby mode slightly increases.
• When setting the AV receiver to standby mode while Zone 2/3
is active, the Z2/3 indicator is dimly lit.
• Activating Zones in the main room when the listening mode is
set to Pure Audio will automatically switch it to Direct.
• The Zone 2 volume, tone, and balance function have no effect on
ZONE 2 PRE/LINE OUT when the “Zone2 Out” setting is set
to “Fixed” (
➔ page 65
).
• The Zone 3 volume, tone, and balance function have no effect on
ZONE 3 PRE/LINE OUT when the “Zone3 Out” setting is set
to “Fixed” (
➔ page 65 ).
• Even if you repeatedly press the remote controller’s ZONE to
select zones, the last zone selection will be retained once you
have switched to other components by pressing other REMOTE
MODE after pressing ZONE.
2 To select an input source for Zone 2/3, press ZONE
repeatedly, followed by INPUT SELECTOR.
To select AM or FM, press the TUNER input selector
and ZONE repeatedly.
Note
• You cannot select different AM or FM radio stations for
your main room and Zone 2/3. The same AM/FM radio
station will be heard in each room.
3 To turn off Zone 2/3, press ZONE repeatedly,
followed by RECEIVER.
Tip
• The corresponding trigger output goes low (0 volts).
1 press ZONE repeatedly.
2 Use VOL / to adjust the volume.
1 Press ZONE 2 or ZONE 3 (the Z2/3 indicator on
the display flash).
2 Use MASTER VOLUME control within 8 seconds
to adjust the volume.
1 Press ZONE repeatedly, and then press MUTING.
1 On the AV receiver, press ZONE 2 or ZONE 3.
2 Press the AV receiver’s TONE repeatedly to select
“Bass”, “Treble” or “Balance”.
3 Use –/+ to adjust the bass, treble or balance.
• You can boost or cut the bass or treble from –10 dB
to +10 dB in 2 dB steps.
• You can adjust the balance from 0 in the center to
+10 dB to the right or +10 dB to the left in 2 dB
steps.