Onkyo AV RECEIVER TX-NR5009 - Manual (Page 58)

58
En
Sound Program Edit
■
Sound Program
`
Stereo Source 1, Stereo Source 2, Stereo Source 3,
Multich Source 1, Multich Source 2, Multich
Source 3
When playing back different content types on the same
source, or when listening to a single content type on
different sources, you can pre-register the settings that
best suit each content in “Sound Program”. The
registered settings can then be called up and modified in
one set. Use “Sound Program Edit” to register and
modify a combination of settings.
Tip
• To select the registered settings, see “Sound Program”
(
➔ page 69
).
■ Listening Mode
You can assign a default listening mode that will be
selected automatically when you select the sound
program.
The “Last Valid” option means that the listening mode
selected last will be used.
The “Straight Decode” option means that straight
decoding listening mode (Dolby Digital, DTS, etc.) is
selected.
■
Subwoofer
`
No, Yes
You can choose whether or not to use the subwoofer with
the sound program.
■
Music Optimizer *1
`
Off, On
See “Music Optimizer” (
➔ page 70
).
■
Equalizer *1
` Off
`
Manual:
The manual setting in “Equalizer Settings”
(
➔ page 54
) is applied.
■ Audyssey *1
`
Off, Movie, Music
See “Audyssey”.
■
Dynamic EQ *1*2
`
Off, On
See “Dynamic EQ” (
➔ page 59
).
■
Dynamic Volume *1*2
`
Off, Light, Medium, Heavy
See “Dynamic Volume” (
➔ page 59
).
■
Dolby Volume *1
` Off, On
See “Dolby Volume” (
➔ page 56
).
Note
• “Listening Mode” is only available when the input signal
matches the setting of “Sound Program”.
• You cannot select the “Subwoofer” setting if you set to “No” in
the “Speaker Configuration”.
• “Music Optimizer” is only available when “Stereo Source 1”,
“Stereo Source 2” or “Stereo Source 3” is selected.
• When “Audyssey Quick Start” has been used for measurement,
the “Audyssey”setting cannot be selected.
*1 This setting cannot be used when the “Listening Mode”
setting is set to “Pure Audio” or “Direct”.
*2 To enable this setting, you must first perform the Room
Correction and Speaker Setup.
Items can be set individually for each input selector.
Main menu Source Setup
Audyssey
■
Audyssey
`
Off
` Movie:
Select this setting for movie material.
The Audyssey indicator lights.
`
Music:
Select this setting for music material.
The Audyssey indicator lights.
Note
• If the “Audyssey” setting is set to “Off”, the “Equalizer”
settings are applied (
➔ page 54
).
• When “Audyssey Quick Start” has been used for measurement,
the “Audyssey”setting cannot be selected.
• Audyssey equalizing does not work with DSD sources.
Source Setup
Preparation
Press the input selector buttons to select an input source.
The tone for each speaker is set automatically by
Audyssey MultEQ
® XT32 Room Correction and
Speaker Setup. To enable the following settings, you
must first perform the Room Correction and Speaker
Setup (
➔ page 33
).
These technologies cannot be used when:
• a pair of headphones is connected, or
• Speakers B is being used, or
• either Pure Audio or Direct listening mode is selected.