Onkyo AV RECEIVER TX-NR5009 - Manual (Page 47)

47
En
Advanced Operations
Advanced Setup
The on-screen setup menus appear on the connected TV
and provide a convenient way to change the AV receiver’s
various settings. Settings are organized into 9 categories
on the main menu.
Carry out the settings by using the on-screen display.
Note
• This procedure can also be performed on the AV receiver by
using SETUP, the arrow buttons, and ENTER.
• During Audyssey MultEQ ® XT32 Room Correction and
Speaker Setup, messages, etc., that are displayed on the TV
screen will appear in the Display.
Explanatory Notes
The on-screen menus appear only on a TV that is
connected to the
HDMI OUT MAIN. If your TV is
connected to other video outputs, use the AV
receiver’s display when changing settings.
This section describes the procedure for using the
remote controller unless otherwise specified.
On-screen Setup Menus
Input/Output Assign
(
➔ page 48
)
Miscellaneous
(
➔ page 64
)
Speaker Setup
(
➔ page 51
)
Hardware Setup
(
➔ page 65
)
Audio Adjust
(
➔ page 55
)
Remote Controller
Setup (
➔ page 79
)
Source Setup
(
➔ page 58
)
Lock Setup
(
➔ page 69
)
Listening Mode Preset
(
➔ page 64
)
MENU
1. Input/Output Assign
2. Speaker Setup
3. Audio Adjust
4. Source Setup
5. Listening Mode Preset
6. Miscellaneous
7. Hardware Setup
8. Remote Controller Setup
9. Lock Setup
1. Monitor Out
2. HDMI Input
3. Component Video Input
4. Digital Audio Input
5. Analog Audio Input
1. Input/Output Assign
1. Volume Setup
2. OSD Setup
6. Miscellaneous
1. Speaker Settings
2. Speaker Configuration
3. Speaker Distance
4. Level Calibration
5. Equalizer Settings
6. THX Audio Setup
2. Speaker Setup
1. Remote ID
2. Multi Zone
3. Tuner
4. HDMI
5. Auto
Standby
6. Network
7. Firmware
Update
7. Hardware Setup
1. Multiplex/Mono
2. Dolby
3. DTS
4. Audyssey
DSX
5. Theater-Dimensional
6. LFE
Level
7. Direct
8. Sound Program Edit
3. Audio Adjust
1. Remote Mode Setup
2. Activities
Setup
8. Remote Controller Setup
1. Audyssey
2. IntelliVolume
3. A/V
Sync
4. Name Edit
5. Picture Adjust
6. Audio Selector
4. Source Setup
Setup
9. Lock Setup
1. BD/DVD
2. VCR/DVR
3. CBL/SAT
4. GAME
5. PC
6. AUX
5. Listening Mode Preset
Common Procedures in Setup Menu
1 Press RECEIVER followed by SETUP.
Tip
• If the main menu doesn’t appear, make sure the appropriate
external input is selected on your TV.
2 Use / to select a menu, and then press ENTER.
3 Use / to select a target, and then press ENTER.
4 Use / to select an option, and use / to change
the setting.
Press SETUP to close the menu.
Press RETURN to return to the previous menu.
RETURN SETUP
RECEIVER
ENTER
/ / /
Menu selection
Setting target
Setting options (default setting underlined)
Main Menu Speaker Setup
■
Subwoofer
`
1ch:
Audio signal is outputted from SW1 jack
only.
`
2ch:
Audio signal is outputted from SW1 and
SW2 jacks.