Oki B8300 - Manual (Page 47)

46 — Configuration settings
Default settings
The default settings allow detailed print conditions to be set for printing without any printer driver (for
example, printing from MS-DOS and printing from a computer without any printer driver installed). The
setting items are shown below.
While some items can be set either in the printer driver or on the operator panel, values set in the printer
driver override those set on the panel. Use the printer driver to set options where possible.
Smoothing
SMOOTHING reduces jagged edges (jaggies).
This is seen at roundish curved portions of
characters and images to be printed and
improves perceived resolution.
Default setting: On
Smoothing on or off can be selected.
Copies
COPIES is set when the number of copies to be
printed is set.
Default setting: 1
The number of copies can be set from 1 to 999.
Orientation
ORIENTATION allows portrait or landscape
orientation to be selected for printing.
Default setting: PORTRAIT
PORTRAIT or LANDSCAPE can be set.
Default paper size
The paper size to be used for printing under
normal conditions is set.
Printing will be performed on to the specified
size paper unless otherwise specified.
Default setting : A4 or 8½ x 11.
(The operator panel on the main unit is
used, the sizes are displayed as follows in
the display: TABLOID, LEGAL, FOOLSCAP,
LETTER, EXECUTIVE, INVOICE, A3, B4, A4,
B5, and A5.)
Default paper type
The paper type to be used for printing under
normal conditions is set.
Printing will be performed on to the specified
type paper unless otherwise selected.
Default setting: PLAIN
Plain paper, pre-printed paper, recycled paper,
transparency film, letter head paper,
pre-punched paper or colour paper can be set.
Default output tray
The output tray to be used for printing under
normal conditions is set. Printed sheets will be
output to the specified tray unless otherwise
specified by application software.
Default setting: Depends on installation of
peripheral devices.
> The trays that can be selected depend on
installation of peripheral devices. This
item itself may not be selected.
PCL settings
PCL SETTINGS is used to assign a part of a
character code set to characters of a specified
country choice within the PCL symbol set.
(Used when different symbols are used
depending on the country.)
Default setting: “1” (Roman-8)
Two lists can be printed using options available
under
LIST PRINT.
Select the desired symbol set item from the
operator panel and register it.
PostScript settings
This setting specifies whether an error page
describing the cause of an error is printed or
not when a PostScript error has occurred.
Selections are available to choose printing or
not printing of error pages.
Default setting: Not print