Oki B8300 - Manual (Page 59)

Troubleshooting and maintenance — 58
Misfeed in the paper feed area
Be sure to follow the misfeed removal sequence.
Do not pull the paper tray out first as paper may
be located between the paper tray and the paper
feed section. If the tray is pulled first, the misfed
paper may be torn and difficult to remove.
The following procedure shows the removal
sequence when the machine is equipped with a
duplex module. If the machine is not equipped
with a duplex module or any output device, the
procedure is basically the same. The left side of
the machine must be opened and cleared before
the paper tray is pulled out.
Misfeed in paper tray 1
1. Unlatch the duplex module and slide it to
the left. Unlatch the module and gently
move the module away from the machine.
If the machine is not equipped with a
duplex module, open the side cover.
2. Remove the misfed paper. Be careful not
to tear the misfed paper during removal.
The paper may not be extending out very
far from inside the machine but it must be
removed. . If this is not possible, go to the
next step.
3. If misfed paper is not found in step 2, pull
out paper tray 1 and remove the misfed
paper carefully.
4. Gently close the paper tray. Push the
paper tray back into the machine.
5. Gently close the duplex module. If the
machine is not equipped with a duplex
module, close the side cover. After
closing, confirm that the misfeed
message has been cleared and the
normal display appears.
6. If paper drops beyond the rear side of the
paper tray that has been pulled out,
remove the paper tray and then remove
the paper.
7. After pulling out the paper tray until it
stops, gently lift and pull the tray to
remove it. To reinstall the paper tray,
insert it at an angle and then push it into
the machine.
8. To remove a paper tray from a stand/
paper drawer, pull the tray out until it
stops then rotate it to the left to
disengage it from the stand. When
reinstalling it, place the left rear of the
drawer into the slot and rotate the drawer
to the right and into the stand.
Installation of trays in the stand/3 x 500 sheet
paper drawer
The middle and lower trays cannot be installed
in the upper tray position and the upper tray
cannot be installed to the middle and lower tray
positions. (These cannot be pushed into the
machine. ) Take care not to re-install a tray
wrongly after removing it.