Oki B8300 - Manual (Page 55)

Key operator programs — 54
Key operator code change
This program is used to change the key
operator code.
The key operator must register a key operator
code number and use this number to gain
access to key operator programs. Only one key
operator code number can be registered.
The factory has registered five zeros (00000) as
the code number to allow initial access to the
programs. It is recommended that the key
operator use the factory number for initial entry
into the programs and then change the number
using the program
Default settings
These programs are used to adjust the settings
of various printer functions from the factory
default settings or to cancel the settings.
Print density level
This program is used to adjust the lightness or
darkness of prints. The print density level can
be selected from the following options:
LIGHTEST
LIGHTER
NORMAL
DARKER
DARKEST
Disable notice page printing
This program is used to disable notice page
printing.
Disable test page printing
This program is used to disable test page
printing. If this program is set, printer test page
printing using custom settings cannot be
executed.
A4/LT auto select
If this program is set, and printing on to
Letter (8½"
x 11") size paper is selected but not
available, the printer will automatically
substitute A4 size paper in place of Letter if A4
paper is available.
Letter size paper cannot be automatically
selected in place of A4.
Interface settings
These programs are used to control data
transmitted to the parallel port or network port
of this printer.
Hexadecimal dump mode
This program is used to output the print data
from a computer in the hexadecimal dump
format with corresponding characters (ASCII).
This program is used to check proper
transmission of print data from the computer to
the printer.
Output example of hexadecimal dump mode
(A4 portrait)
PDL for parallel port
This program is used to specify a printer
language to emulate when the printer is
connected to a computer through a parallel port.
> It is recommended to leave the default
setting at AUTO (unless an error due to
this setting occurs frequently.
PDL for network port
This program is used to specify a printer
language to emulate when the printer is
connected to a computer through the network
port. The setting items are the same as those of
PDL for parallel port.
> It is recommended to leave the default
setting at AUTO (unless an error due to
this setting occurs frequently.
Setting item Description
Auto The printer language will switch
automatically in accordance
with data from the computer.
PostScript PostScript is used to print the
data from the computer.
PCL PCL is used to print the data
from the computer.