Oricom ULTRA 9400 - Manual (Page 22)

20
Handset Sound Signals
Signal Meaning
A long warbling tone (with
ringer on)
Signals an incoming call
Three short beeps (several
times)
Page signal
One beep every 7 seconds Low battery warning
Charge/In Use Indicator
When the in use/charging indicator on the base is lit, the
handset is correctly seated in the charging cradle.
VMWI Indicator on Handset
ImpORTANT:
In order to use this unit’s Visual Message Waiting Indicator (VMWI)
feature, you must subscribe to this service from your service
provider.
If you have subscribed to a voice messaging service, the
VMWI indicator on the top of the handset flashes when you
receive a new message from your service provider.
Speakerphone Operation
Note:
If you are using the speakerphone, remain close to
handset so the party you are speaking to can hear you.
If you are using the handset and want to switch to the
speakerphone, press the [ ] button, press [ ] again to
end conversation.
If you are using the speakerphone and want to switch to
the handset, press the [ ] button, press [ ] again to
end conversation.
Making a Call
1. Press the [ ] or [ ] button. Dial the desired number.
- OR -
Dial the number first, then press the [
] or [ ]
button.
- OR -
Press the [ ] or [ ] button to select the desired
record, then press the [ ] or [ ] button
2. When finished, press the [ ] or [ ] button to hang
up.
TELEpHONE OpERATION