Oricom ULTRA 9400 - Manual (Page 30)

28 CALLER ID
1. When the handset receives a second call, the number
of the caller appears on the display. It will display for 20
seconds or until you press a key on the phone.
2. Press [ R ] wait for dial tone, then press [ 2 ] to put the
current call on hold and talk with the second caller.
3. Subsequent presses [R ] to listen for dial tone then
press [ 2 ] will toggle you between these 2 callers.
Receiving CID Records
When you receive a call, the Caller ID information is
transmitted between the first and second ring. The Caller ID
information appears on the display while the phone rings,
giving you a chance to monitor the information and decide
whether or not to answer the call.
Storing CID Records (In CID Memory)
If you are not at home or cannot answer, your telephone’s
Caller ID memory stores the data for the 40 most recent
calls you received so you can see who called while you
were unavailable. When the 41st call is received, the oldest
Caller ID record (1st call) is automatically deleted.
You may review the stored information at any time. Calls
received since your last review show as NEW in the display.
Calls that have not been previously reviewed but were
received from the same number more than once show as
REPT in the display.
Reviewing CID Records
As calls are received and stored, the display is updated to
let you know how many calls have been received. To scroll
CID records:
1. Make sure the phone is OFF (not in talk mode).
2. Press the [ ] button to review the newest CID record.
3. Press the [ ] button to review the oldest CID record
first.
Dialling a CID Number
1. Make sure the phone is OFF (not in TALK mode).
2. Use the [ ] or [ ] button to display the desired
record.
3. Press the [ ] or [ ] button. The number dials
automatically.
Note:
Depending on (a) how the incoming caller’s phone number
is formatted when it is received, and (b) whether or not
you previously pre-programmed your local area code into
the set up menu, you may need to adjust the format of the
incoming caller’s stored phone number before making the
call, press the
[ ] button to adjust the number, and try
again.