Oricom ULTRA 9400 - Manual (Page 42)

40
Registration
Your packaged handset(s) are pre-registered and ready to
use. It is not recommended that a handset be registered
again unless absolutely necessary.
From the Handset Setup Menu:
1. Press the [ ] or [ ] button to scroll to the
REGISTRATION sub-menu.
2. P r e s s t h e [ ] b u t t o n t o e n t e r t h e m e n u .
REGISTRATION 1YES 2NO - - - shows in the display
The default setting is “2NO”.
3. Use the touch-tone pad to select [ 1 ] for YES or [ 2 ] for
NO. Or use the [ ] or [ ] button to scroll to 1YES or
2NO.
4. If you select 1YES, press the [ ] button to confirm
your selection. HOLD BASE PAGE WAIT FOR BEEP
shows in the display. (Your handset should be held near
the base during registration process.)
5. Press and hold the [ ] button on the base unit you
hear a tone at the handset. HANDSET X REGISTERED
shows in the handset display, where X is the handset
number. You may now rename your handset. (Refer to
Step 3 & 4 of Handset Name Section)
De­Registration
This feature allows you to remove a registered handset
from base. During the de-registration process, keep the
handset near the base.
From the Handset Setup Menu:
1. Press the [ ] or [ ] button to scroll to the
DEREGISTRATION sub-menu.
2. Press the [ ] button to enter the menu. DE-
REGISTRATION 1YES 2NO - - - shows in the display
The default setting is “2NO”.
3. Use the touch-tone pad to select [ 1 ] for YES or [ 2 ] for
NO. Or use the [ ] or [ ] button to scroll to 1YES or
2NO.
WARNING:
It is not recommended that a handset be de-registered unless
absolutely necessary because once a handset is de-registered, that
handset’s telephone features cannot be used until the handset is re-
registered.
ADvANCED SETTINGS