Quadra-Fire 3100 31M-ACC-MBK - Manual (Page 23)

March 2, 2007 7033-277C Page 23
3100 Wood Stove Series (ACC) R
B. Leg Kit and Ash Removal Installation
(ARS) for Step Top Uni-Body
Do NOT tilt the unit on the cast iron legs.
• Tilting could lead to property damage.
• Lift the unit upright and place it into position on the
fl oor protector.
CAUTION
Lay stove flat on its
back on protective
padding or pallet
Insert 2 bottom
screws loosely
Ash Drawer
Leg Brackets
Begin installing the ARS System.
1. Follow steps 1 through 6 on page 21.
Installing Leg Kit
1. Remove leg mounting brackets packaged inside fi rebox.
2. Attach the 2 bottom screws of the mounting brackets to the
bottom of the stove with 1/4”-20 Phillips screws. These screws
are located in the component pack. Leave the bottom 2 screws
loose so you can slide the ash pan assembly bottom slots over
the screw heads. This allows the weight of the ash pan to
rest on the screws while you are attaching the top 2 screws.
Once the ash pan is attached, tighten all screws.
3. Loosely assemble bolts into the corner of the mounting brack-
ets for leg attachment.
4. Slide legs onto mounting brackets and tighten. Make sure the
legs are up against the bracket. There are leveling bolts in 2
legs. These leveling legs should be in opposite corners.
5. Carefully stand stove up and place in desired location. Do NOT
tilt up on the cast iron legs, it could damage the legs.
6. Use leveling bolts on legs to stabilize and level stove.
Finishing the ARS Installation
1. Follow steps 1 through 3 on page 22. See also Figure 22.2.
NOTE: The Ash Removal System, must be
installed fi rst before installing the legs.
Figure 23.1
Figure 23.2
Leg Mounting Brackets are
packaged inside firebox.
Leveling Legs at
opposite corners