Quadra-Fire 3100 31M-ACC-MBK - Manual (Page 24)

Page 24 7033-277C March 2, 2007
R
3100 Wood Stove Series (ACC)
NOTE: When the speed control is turned clockwise,
it will click on to high speed. Continue to turn the
speed control clockwise to decrease the speed. At
full clockwise, the blower should blow gently, but
should not stop.
1. With the appliance plugged in, turn the speed
control knob to slow (full clockwise).
2. With a small screwdriver, adjust the blower speed
by turning the adjustment mechanism through the
hole on the side of the speed control.
3. Adjust the speed so the blower runs slowly, but
does not stop. Turn clockwise to slow the blower
and counterclockwise to increase the speed.
The blower speed control for this unit is adjusted at the factory,
and normally does not require further adjustment.
D. Adjusting The Blower Speed Control C. Door Handle Assembly
1. Install washer on door handle shaft.
2. Slide door handle through door.
3. Install second washer(s) as shown.
4. Install key in groove.
5. Align groove in latch cam with key; slide latch cam
over shaft
6. Install locknut but do not overtighten as the door
handle needs to move smoothly.
7. Install spring handle turning in a counter-clockwise
motion to desired location on door handle rod.
Figure 24.1
Locknut
Door Cross Section
(example)
Latch Cam
Spacing
Washers
Square Key
Door Handle
Spring
Handle
CAUTION
• Do NOT overtighten lock nut.
• Door handle needs to move smoothly.