T+A Elektroakustik K1 CD-RECEIVER - Manual (Page 15)

15
Menu point 1: BALANCE
AMP OK
CE NTE R 0
Introduction:
The 'BALANCE' function is used to adjust
the balance between the left and right chan-
nels, e.g. to compensate for non-symmetrical
speaker positioning. The balance setting is
infinitely variable.
Operation:
To change the balance setting press the re-
mote control buttons in the sequence shown
above. The screen then shows the pre-
amplifier's current balance setting, e.g.:
'CENTER 0' = Stereo centre neutral
The balance setting can be adjusted to left or
right in 31 steps.
(     or    button)
Possible adjustment range:
'BAL L 30' (stereo centre fully left)
to
'BAL R 30' (stereo centre fully right)
Any change you make takes effect immedia-
tely. The function is terminated by pressing
the
    button.
If none of the menu control buttons
(
   ,    ,     or    ) are pressed
for a period of about ten seconds, the unit
interrupts the special functions menu and
reverts to the standard display. (time-out)
Note:
If the stereo centre is set to any value other
than neutral, every time you alter the volume
level the balance setting will appear briefly
on the screen after the current volume value,
e.g. 'VOL 27 L', which means that the stereo
centre is offset to the (L)eft.