T+A Elektroakustik K1 CD-RECEIVER - Manual (Page 21)

21
Menu point 4: SETUP - SETUP function 4: INPUT SENSITIVITY AUX/TV
OK
SE TUP AU X M IN
OK AMP AMP
press
4x 3x
Introduction:
The sensitivity of the AUX/TV input can be
changed to any of four settings so that you
can continue to use source devices which are
quieter than normal without suffering a
disturbing change in volume when you
switch from one source to another:
'AUX MIN'
'AUX LOW'
'AUX TV'
'AUX MAX'
The volume corresponds to the setting you
choose, i.e. it is quietest at the 'MIN' setting
and loudest at the 'MAX' setting.
Note:
To avoid overloading the input sensitivity
should be set to 'MIN'.when a high level
source is connected to the AUX/TV input.
Operation:
To alter input senstivity of the AUX/TV in-
put press the remote control buttons in the
sequence shown above.
The screen then shows the current brightness
level e.g.:
'AUX MIN'
You can change the current setting by pres-
sing the remote control buttons
    oder
   . Any change you make takes effect im-
mediately.
If none of the menu control buttons
(
   ,     /     oder    ) are pres-
sed for a period of about ten seconds, the unit
interrupts the special functions menu and
reverts to the standard display. (time-out)