T+A Elektroakustik K1 CD-RECEIVER - Manual (Page 52)

52
TROUBLE-SHOOTING
Many problems have a simple cause and a
correspondingly simple solution. The fol-
lowing section describes a few difficulties
you may encounter, and the measures you
need to take to cure them.
If you find it impossible to solve a problem
with the help of these notes please disconnect
the unit from the mains and ask your author-
ised
 specialist dealer for advice.
Problem: Machine does not switch on
(screen
and symbol over
    button not glowing).
Cause: Mains lead not plugged in cor-
rectly.
Remedy: Check connections, push plugs
in firmly.
Problem: Whistling or hissing sounds
from the speakers.
Cause: The aerial lead is too close to
the mains lead or the Cinch ca-
bles.
Remedy: Re-position the cables and keep
them well apart. Use the house-
hold aerial or a radio cable.
Problem: System responds correctly to
manual operation of the but-
tons, but does not react to re-
mote control commands.
Cause1: Incorrectly inserted batteries or
flat batteries in the remote con-
trol handset.
Remedy: Re-fit batteries correctly or fit
new ones.
Cause2: No visual contact between sys-
tem and remote control trans-
mitter.
Remedy: Ensure direct line-of-sight con-
tact to the remote control trans-
mitter.
Note that glass doors may pre-
vent the system working prop-
erly.
Maximum range between
transmitter and receiver approx.
6 metres.
Position the system in such a
way that the RC receiver and the
optional E 2000 is not subjected
to direct sunlight or strong arti-
ficial lighting.
Fluorescent and energy-saving
lamps are powerful sources of
interference.
Cause3: You are using an incorrect ver-
sion of the optional E 2000 re-
mote control receiver. The cor-
rect type of receiver has two
exposed screw heads on the un-
derside of the case.
Remedy: Please refer to your  spe-
cialist dealer.