Step 2: charge your handheld, Step 3: set up your handheld, Step 1: connect the hotsync – Tungsten Affinity TUNGSTUN T3 User Manual
Page 17: Cradle to the computer
Step 1: Connect the HotSync
®
cradle to the computer
3
Step 1: Connect the HotSync
®
cradle to the computer
IMPORTANT
Windows NT users cannot use a USB cradle/cable and port. You must
use a cradle with a serial port connection (sold separately).
a.
Locate the USB icon and ports on your computer.
b.
Plug the USB connector into a USB port on your computer.
c.
Connect the adapter cable to the back of the cradle.
NOTE
Your adapter may connect to the back of the USB connector, not to the
cradle itself.
d.
Plug the adapter into a working electric outlet.
Step 2: Charge your handheld
a.
Place your handheld in the cradle for at least two hours for an initial charge.
Your handheld’s indicator light glows steady green when it is charging.
b.
After it is charged, remove the handheld from the cradle by gently tilting it
forward and then lifting it from the cradle.
Once your handheld is set up and in daily use it requires 15 to 30 minutes of charge
time per day, depending on usage.
USB port
USB connector
USB icon