Trango Broadband TrangoLink-10 - Manual (Page 14)

Configuration Essentials to Establish a Wireless Link
Trango Broadband Wireless — TrangoLINK-10 User Manual Rev. E 3.0 page 10
Remote Unit Configuration Screen
Establish a browser session with the RU. Click on the configuration link and set the following parameters:
1. Set IP, subnet, and gateway. (This is only necessary to manage the radios via TCP/IP.)
2. Set default Opmode to “ON” in the RU.
3. Leave “Auto Scan Master Unit” switch on, or set Active Channel to match MU.
4. Update system setting flash memory by clicking Save and Activate Settings button.
5. Click Activate Opmode.
At this point the RU will begin scanning all channels actively searching for the MU. Once the MU is detected, the
authentication and association process will begin.

Note: The RED LED on the bottom of the MU should be lit, indicating that the radio is in Opmode “ON” and is
transmitting.

Note: The amber light on the bottom of the RU indicates the relative signal strength (RSSI) of the signal received.
A steady light indicates a strong signal. A blinking light indicates weaker (although perhaps sufficient) signal
strength.