Trango Broadband TrangoLink-10 - Manual (Page 20)

Configuration Remote Unit System Information
Trango Broadband Wireless — TrangoLINK-10 User Manual Rev. E 3.0 page 16
Parameter Description Associated Page and Notes
match the RU’s RSSI Target setting. The user
does not manually set the RU’s transmit power.
RF RX Threshold Specifies the receiver sensitivity of the radio.
This user-changeable parameter is a powerful
tool that is useful for mitigating the effects of
interference. The radio will not process any
signals receieved that are weaker than the RF RX
threshold. Advanced page
CLI Command:
rfrxth <ism> <-90|-85|-80|-75|-70|-65>
Active Channel Current channel. If MU Autoscan feature is on,
and if the RU is not associated to an MU, it will
continue to cycle through all channels until it
detects and MU. Informational Parameter
Broadcast Packet
Filter This switch (0) enables/disables the blocking of
Ethernet control packets, except ICMP and ARP,
to reduce the amount of unnecessary overhead
introduced to the wireless link. Configuration page
sw 0 [<on | off>]
MU Autoscan This switch (1) is to turn MU Autoscan on or off. Configuration page
sw 1 [<on | off>]
TCP/IP for MU This switch (2) when on, allows users at the MU
side of the network to telnet or HTTP into the
RU. Configuration
sw 2 [<on | off>]
Remarks User definable radio information (i.e. customer
name, address of installation, and so on).
Maximum 28 characters can be stored. Informational Parameter