Trango Broadband TrangoLink-10 User Manual
Page 31
Command Set Summary
Trango Broadband Wireless — TrangoLINK-10 User Manual Rev. E 3.0
page 27
Command Description
OFF
ON
Remark
ru reboot
reboot Remote Radio
se
ru speedtest [<packet length>
<file size>]
perform speedtest
<pkt len> = 64..1760 bytes
<file size> = 10..100 Mbytes
se
default:
<pkt len> = 1760 bytes
<file size> = 10 MBytes
ru sysinfo
request Remote’s system information
se
ru testrflink [<packet length>]
perform RF loopback test testrflink
<pkt len> = 64..1760 bytes
se
default:
<pkt len> = 1760 bytes
reboot reboot
unit
se
se
remarks [<str>]
string length should be 1 to 28 characters
se
se
reset [<all | 0…n>]…
reset radio to the firmware default
n# = 0..2
Master:
0 - Channel Table, Active Channel = 1 h,
Switches, and Remarks
1 - TX Power = Max, RF Threshold = -90
dBm, Target RSSI = -60 dBm, MIR
Downstream = 10000 kbps, Upstream =
10000 kbps
2 - SNMP Community String (Read/Write)
= (public/private)
Remote:
0 - Channel Table, Active Channel = 1 h,
Switches, and Remarks
1 - TX Power = Max, RF Threshold = -90
dBm
2 - SNMP Community String (Read/Write)
= (public/private)
se
rfrxth <ism> <-90 | -85 | -80 | -
75 | -70 | -65>
specify RF RX Threshold
se
se
default = -90 for both
band
rfrxthreshold …
same as “rfrxth” se
se
rssi
display current RX RSSI
se
save
same as “updateflash” se
se
save mm
same as “updateflash mainimage” se
se
save ss
same as “updateflash systemsetting” se
se
set defaultopmode [<on | off>]
set or display default Opmode
se
se
set httpport [<port #>]
set or display HTTPD port number
se
se
default = 80
set mir [<downstream,
kbps>][<upstream, kbps>]
set or display MIR
<kps> = 100..10000
se se
set rssitarget <dB>
set Target RSSI Threshold
It must be -45 to –75, and +5 dB higher
than RF RX Threshold.
se se
set snmpcomm [<read | write>]
display or assign SNMP community string
se
se
set telnetport [<port #>]
specify telnet port, <port #> = 1..65534
se
se
default = 23
ssrssi <ch #> <v | h>
display RSSI on the current channel
se
survey <ism> <time, sec> <h
|v> spectrum analysis of entire RF band
se
sw 0 [<on | off>]
set sw #0 – packet filter for
broadcast/multicast
se se
default
=
on
sw 1 [<on | off>]
set sw #1 – HTTPD service
se
se
default = on
sw 2 [<on | off>]
set sw #2 – Auto scan Master signal
se
se
default = on
sw 3 [<on | off>]
set sw #3 – Auto power leveling Remote
Unit
se se
default
=
on
sysinfo
display system configuration
se
se
temp
display current temperature
se
se