Trango Broadband TrangoLink-10 User Manual
Page 18
Configuration
Basic Diagnostics
Trango Broadband Wireless — TrangoLINK-10 User Manual Rev. E 3.0
page
14
Parameter
Description
Associated Page and Notes
set mir [<downstream kbps, 100..10000>
<upstream kbps, 100..10000>]
Downstream
Throughput
Current throughput from Master Unit to
Remote Unit.
Informational Parameter
Upstream
Throughput
Current throughput from Remote Unit to
Master Unit.
Informational Parameter
Active Channel
Current RF channel and polarization (v)ertical or
(h)orizontal.
Configuration page
CLI Command: freq <ch> <pol>
RF RX Threshold
Specifies the receiver sensitivity of the radio.
This user-changeable parameter is a powerful
tool that is useful for mitigating the effects of
interference. The radio will not process any
signals receieved that are weaker than the RF
RX threshold.
Advanced page
CLI Command:
rfrxth <ism > <-90|-85|-80|-75|-70|-65>
RF TX Power
Transmit power of the radio (not including
antenna gain)
Advanced page
CLI Command:
power <setism> <max |min| dBm>
Channel Table
Assigns channel numbers to actual
frequencies of operation. The
default channels
1 – 6 are assigned to ISM band. Note: All
channels may be re-assigned as desired by the
user.
Default settings allow optimum use of
the available spectrum. The frequencies
assigned on the Master Unit must match those
on the Remote Unit.
Advanced page
CLI Command:
freq writechannel [<ch#> <freq>] ...
Broadcast Packet
Filter
This switch (0) enables/disables the blocking of
Ethernet control packets, except ICMP and ARP,
to reduce the amount of unnecessary overhead
introduced to the wireless link
Configuration page
CLI Command:
sw 0 [<on | off>]
Remarks
User definable radio information (i.e. customer
name, address of installation, and so on).
Maximum 28 characters can be stored.
Informational Parameter
CLI Command:
remarks <remarks>
Eth In
Eth In: Counter for Ethernet packets that
entered via the Ethernet port of the radio.
Informational Parameter
Eth Out
Counter for Ethernet packets that exited via
the Ethernet port of the radio.
Informational Parameter
RF In
Counter for Ethernet packets that entered
over-the-air into the radio.
Informational Parameter
RF Out
Counter for Ethernet packets that exited over-
the-air out of the radio.
Informational Parameter