Trango Broadband TrangoLink-10 - Manual (Page 17)

Configuration Basic Diagnostics
Trango Broadband Wireless — TrangoLINK-10 User Manual Rev. E 3.0 page 13
Table 1: Reference Table of Master Unit System Information Parameters
Parameter Description Associated Page and Notes
Hardware Version Hardware version is factory-set and cannot be
changed by user. Permanent with Hardware
FPGA Version and
Checksum This parameter provides information about the
current FPGA firmware loaded in the radio. See website for latest FPGA firmware and
release notes.
Firmware Version The Firmware version is the initial four
characters of this string. (i.e. 1p60 = 1.60 ) See website for latest firmware version and
release notes.
Device ID MAC address of the radio. Permanent with hardware
Opmode Current operation mode of the radio. “On”
indicates transmitting. “Off” indicates not
transmitting. Configuration page.
Note: in order to change the radio from
Opmode “On” to Opmode “Off,” you must
change the default Opmode to “Off,” and
reboot the radio.
CLI Commnand: opmode [<on | off>]
Default Opmode Determines the Opmode (“ON” or “OFF”) of the
radio after reboot/power cycle. When the
parameter is set to “ON,” the radio will progress
into Opmode “ON” automatically after
reboot/power cycle. Note: If radio startup is
interrupted within 30 seconds after reboot (by
opening a Telnet session) the radio will remain
in Opmode “OFF.” Configuration page
CLI Command:
set defaultopmode [<on | off>]
System Up Time Time since radio was last rebooted or power
cycled. Informational Parameter
Radio Temperature Current internal temperature of radio. Informational Parameter
[IP]
[subnet]
[gateway] IP, subnet, and Gateway address of radio used to
manage the radio. Configuration page
Note: Changing the IP of the radio could
cause loss of management connectivity.
CLI Command:
ipconfig[< ip> <subnet> <gateway>]
Telnet Port User changeable telnet port of radio. Configuration page
TFTPD status TFTP daemon status (on or off). TFTPD should
be turned on to import a file (such as new
firmware) into radio’s TFTP buffer. Default is
off. Configuration page
Note: TFTPD ON is used in firmware
upgrade process.
CLI Command: tftpd [<on | off>]
Remote ID MAC address of the Remote Unit Configuration page
CLI Command: set remoteid <RU’s MAC>
Status Status of Remote Unit: Connected (wireless
link established), or Disconnected (wireless
link not established). Informational Parameter
RSSI Relative Signal Strength Indicator. Displays
signal strength received from the MU to the
RU. A “?” indicates RU is not connected. Informational Parameter
CLI Command: rssi
Downstream MIR Master Unit to Remote Unit maximum
information rate (in kbps). Advanced page
CLI Command:
set mir [<downstream kbps, 100..10000>
<upstream kbps, 100..10000>]
Upstream MIR Remote Unit to Master Unit maximum
information rate (in kbps). Advanced page
CLI Command: