2 telephone port (pots) features – Telstrat Argent User Manual
Page 25
Argent Terminal Adaptor - User Guide
Version 1.1
Telstra Corporation Limited
Page 25/29
ACN 051 775 556
5.2 Telephone Port (POTS) Features
5.2.1 Call Waiting (CW)
Call Waiting is an Easycall ™ feature so the customer can detect the presence of another
call, while a call is in progress.
a
Turn Call Waiting on:
OH DT * 43 # RSP RH
b
Turn Call Waiting off:
OH DT # 43 # RSP RH
c
Check if CW is enabled or disabled (double tone
indicates that CW is enabled; triple tone indicates
that CW is disabled)
OH DT *#43# RSP RH
d
To release the current call and accept the waiting call
RH (Ring telephone) OH
or RR DT 1
e
To hold the current call and accept the waiting call
RR DT 2
f
To alternate between the two parties
RR DT 2
g
To release current call and connect to call on hold
RR DT 1
h
To reject the waiting call (Fend Off)
RR DT 0
5.2.2 Malicious Call Identification (MCID / MCT)
Malicious Call Identification allows the customer to request the network to trace
malicious calls on a call by call basis.
a
To set Malicious Call Trace during the call
RR DT * 39 # [RH]
b
To set Malicious Call Trace up to 60 seconds after
the caller has released the port
RR DT * 39 # RH
5.2.3 Calling Line Identification Restriction (CLIR or Call Blocking)
Calling Line Identification Restriction, also called Call Blocking, is a service offered to
the calling party to prevent presentation of the calling party's number. The phone number
of the ATA can be restricted from being viewed at the remote end. In order for the ATA
to present a phone number, it must be entered using the ‘AT’ Command (section 4.2).
a
To restrict presentation of CLI on a call by call basis
(Note 1)
OH DT 1831 DN or
OH DT ##31# RH
b
To allow presentation of CLI on a call by call basis
(Note 1)
OH DT 1832 DN or
OH DT **31# RH
c
Check if CLIR is enabled or disabled (double tone
indicates that CLIR is enabled; triple tone indicates
that CLIR is disabled)
OH DT **#31# RH
Note 1:
The dial number prefix (i.e. 1831 or 1832) is required for every call that the
customer wishes to change (override) the network default status of CLIR.