Trimble Outdoors THUNDERBOLT 64057-00-ENG User Manual
Page 18
2 Setting up and Running the ThunderBolt E
16 Trimble ThunderBolt E GPS Disciplined Clock User Guide
To view the Timing Receiver Status and Control information, select
Window/Receiver Status:
4.
To specify the communications port and protocol for your office computer,
right-click in the bottom right of the Trimble GPS Monitor screen and then select
the required COM port and settings.
5.
Connect the Bullet antenna to the ThunderBolt E using the provided antenna
interface cable.
6.
Connect the DB-9M serial cable from the ThunderBolt E to DB-9F on your
computer.
7.
Turn on the +24 V DC power source or plug in the AC/DC converter and then
turn on the power.
The Tx and Rx in the lower left of the status bar indicate the following:
–
If the Tx blinks, the computer is transmitting commands to the receiver.
–
If the Rx blinks, the computer is receiving reports from the receiver.