TAG 1000 - Manual (Page 32)

MIL-BOOK™
OPERATORS MANUAL
- 2-2 -
Figure 2-1 Opening the Notebook
2.2.3 Opening the PCMCIA, FDD, CD ROM/DVD/COMBO, DVD
RW Door
Open doors only when it is required to access components behind them.
To open a door:
1. Insert a small flat edged object (a small sized screwdriver or the edge of a small
coin) into the slot of one of the captive screws securing the access door.
2. Turn the screw counter-clockwise until it comes loose from its socket.
3. Repeat steps 1 and 2 for each screw securing the access door.
4. Use the handle to open the access door. If the access door does not have a handle,
use one of the loosened screws to pull open the door.
Figure 2-2 Opening a Door
2.2.4 Closing the PCMCIA, FDD, CD ROM/DVD/COMBO, DVD
RW Door
Be sure to close and secure the access doors before transporting the MIL-BOOK
1000.
1. Shut the door or put the PCMCIA/FDD/CD-ROM/DVD/COMBO/DVD RW
back in place.
2. Align the door or cover securing screws with their sockets.
3. Use your finger to hold the screw in place. Insert a small flat-edged object ( a
small sized screwdriver or the edge of a small coin) into the slot of one of the
securing screws and turn clockwise until tight.
4. Repeat step 2 and 3 for each securing screw.
2.3 Connecting and Installing Devices
This section gives instructions for installing, removing, changing, or connecting devices
via the notebook external ports or sockets.