TAG 1000 - Manual (Page 35)

MIL-BOOK™
OPERATORS MANUAL
- 2-5 -
I
2.3.4 Loading and Remove Diskettes
To install a diskette,
1. Open the PCMCIA slot/ diskette drive access door.
2. Slide the diskette into the drive with the printed label facing up until it clicks in
place.
3. Press the “Eject” button, on the right side of the floppy drive to remove the
diskette. See Figure 2-6.
2.3.5 PCMCIA Cards
The MIL-BOOK 1000 comes standard with PCMCIA Card Bus slots for added
expansion. The PCMCIA Card Bus slots support two type-II or one type-III PC
card. Since both type II slots are co-located in the same opening, one type III PC
card can be inserted instead of two type II PC cards. The type III PC card
occupies both slots. The MIL-BOOK 1000 supports “hot insertion”. You can
insert the PC card into the slot while the system is powered “On”.
1. Open the PCMCIA slot/diskette drive door.
2. Slide the card into the slot with the insert marking facing up until it seats.
3. To remove the upper card, press the eject button on the left. To remove the lower
card, press the button on the right. (See Figure 2-7).
Figure 2-6 Removing a Diskette
2.3.6 Hard Disk
NOTE
Installing or removing a hard disk when the computer is on can destroy the system board
and hard disk.