Tektronix Waveform Monitors WFM700 Series - Manual (Page 45)

Menus
2- 30 WFM700 Series Waveform Monitors User Manual
Print Menu
When you press the PRINT button, the Abort Printing soft key appears. Press
this soft key to abort the print request.
Status Menu
Press the STATUS button to enter the Status display mode, which displays the
Status menu shown in Figure 2--22. Use the Status display mode to perform the
following tasks:
H View the status of the selected video signal
H View the status of the selected audio signal
H View the status of the auxiliary data in the selected video signal
H View the status of the monitored alarms
H Enable, disable, configure, and view the event log
For more information about using the Status mode displays, refer to Logging on
page 3--32 and Status Displays on page 3--37.
Session
WFM
VECTOR
PICTURE MEASURE
STATUS
GAMUT EYE
AUDIO
MULTI
VIEW
Alarm Status
Status Menu
Show All Alarms
Show General Alarms
Show Serial Alarms
Show Audio Alarms
Show Aux Data Alarms
Show Physical Alarms (WFM700M only)
Done
General Alarms
Serial Alarms
Audio Alarms
Aux Data Alarms
Physical Alarms (WFM700M only)
Alarm Menu
Log Filter
Menu
Video Session
Audio Session
Aux Data Status
Session: Stopped | Running
Reset Session
Event Log Show: All Events | Errors Only
Configure View Filter
Logging: Stopped | Running
Erase Log
Logging Menu
Aud/Vid/Aux Data
Session Menu
Session
Alarm Status
Event Log
Done
Status Display Menu Display
Figure 2- 22: Status menu diagram