Temco Tool 33TDVDSN - Manual (Page 21)

21
TDVDSN Series Direct Vent Gas Fireplace
20007890
Only glass approved by CFM Corporation
should be used on this fireplace.
The top louvre
panel is removed
by lifting the
panel vertically
and pulling it
away from the
appliance. (Fig.
35)
The lower access
door is hinged
along the bottom
edge and is
folded down to
allow access.
1. Turn the fireplace OFF (including the pilot)
2. If the unit has been operating allow time for the
components to cool.
3. Remove the top louvre assembly.
4. Open the lower louvre panel.
5. Release the two clamps securing the lower edge of
the frame by pulling down on the handles. (Fig. 36)
6. Tilt the glass frame out slightly at the bottom, lift the
frame up and away from the fireplace.
7. To replace the glass frame reverse the procedure.
It is necessary to periodically clean the glass. During
start-up condensation, which is normal, forms on the
inside of the glass. This condensation causes lint, dust
and other airborne particles to cling to the glass surface.
Also initial paint curing may deposit a slight film on
the glass. It is therefore recommended that the glass
be cleaned two or three times with a non-ammonia
based household cleaner and warm water (We
recommend gas fireplace glass cleaner) within the
first few weeks of operation.
After the initial cleaning process the glass should be
cleaned two or three times during each operating
season depending on the environment in the house.
• The use of any non-approved replacement glass will
void all product warranties.
• Care must be taken to avoid breakage of the glass.
• Do not operate appliance with glass front
removed, cracked or broken.
• Replacement glass (complete with gasket) is
available through your CFM Corporation dealer
and should only be installed by a licensed
qualified service person.
Clean the glass after the first two weeks of
operation.
Do not clean glass when hot.
Do not use abrasive cleaners.
Do not strike or slam glass.
Operating Instructions
Glass Information
Window Frame Removal
Glass Cleaning Louvre Removal
1.
2.
FP1227
Louvre removal
11/02
Louvre
Glass Panel
FP1227
Fig. 35 Remove top louvre assembly.
FP1228
remove glass frame
11/02
Lower Clamps
Window
Frame As-
sembly
Pull
Clamp
Hook
Push
Clamp
Handle
Window
Frame
Assembly
FP1228
Fig. 36 Window frame assembly removal.
�������
�
��������������
������������
������������������
�������������
��������������������
���������������