TRENDnet Series 300 - Manual (Page 15)

CONTROL FEATURES (continued)
5--3
How to Set Optional Programmable Engine Exerciser (Accessory 11CD)
Proceed with care!
The automatic transfer switch is energized.
!
Setting the Clock (Time and Day)
Step Press Button Display Meaning
1 reset
1234567 (blink)
00 00
¬ f
after self-test,
clears memory
2

hold h, then
press ±1h
1 2 3 4 5 6 7
AM 12 00
¬ f
military 24 hr
or AM/PM
12 hr time
Note Repeat step 2 to toggle between
military (blank display) and AM/PM time.
3
hold ¬
(clock symbol)
1234567 (blink)
00 00
¬ f
hold ¬ while
setting thru
step 7
4
±1h once
(if Daylight
Saving Time)
±1h
do nothing if it
is Standard
Time.
5
h (hold for
fast count)
[00] 00 hour
6
m (hold for
fast count)
00 [00] minute
7
Day Mo Tu We Th Fr
Sa Su
day
8 release ¬ : blinking
time & date
set, clock starts
Programming Engine On-Off Period(s)
Step Press Button Display Meaning
1
Prog.
(do not hold)
1 2 3 4 5 6 7
–– : ––
begin
2 hand
¬
on
3 h start hour
4 m start minute start engine
5 Day start day
Note Successive pressing displays blocks of days:
Mon–Sat, Mon–Fri, Sat & Sun (1 is Monday)
6
Prog. 1 2 3 4 5 6 7
–– : ––
begin
7
Press hand
(2 times)
f
off
8 h stop hour
9 m stop minute stop engine
10 Day stop day
11
¬
: blinking program set
display
clock
button
Figure 5-2. Exerciser display and push buttons
program
button
1h
button
hour
button
minute
button
day
button
reset
button
on/off button
Changing or Checking Time Programs
By operating the Prog. button, the individual commands
as programmed can, at any time, be brought consecutively
into the display for revision or checking. Revisions are
accomplished by programming over the existing programs
using the steps at the left.
Canceling Time Programs
After the selecting the desired program, use the h and
m
buttons to set hours and minutes to zero; the ––:–– will
be displayed. This program has been made ineffective
and will no longer be carried out. To cancel all programs,
press the Res. (reset) button. This clears all memory
including the time base and program storage.
Manual Override
Do not manually override the exerciser unless
you are sure that the controller has been set for
exercise without load (see page 5–2). Failure to
do so could result in possible injury if the transfer
switch operates while the enclosure door is open.
!
Step Press Button Display Meaning
1 hand
¬
hand on
2 hand [ ¬ ] permanent on
3 hand [ f ] permanent off
4 hand
¬ f
back to automatic
Daylight Savings / Standard Time Change
To change to Daylight Savings time, press the ¦1h button
once. Clock advances by one hour and +1h appears in display.
To change to Standard Time, press the ¦1h button again; the
clock sets back one hour and +1h disappears.