Trimble Outdoors JUNO ST handheld - Manual (Page 25)

Juno ST Handheld User Guide 23
Getting Started 2
AC adaptor safety
C
WARNING – To use AC adaptors safely:
– Use only the AC adaptor intended for the Juno ST handheld. Using any other AC
adaptor can damage your product and may void your warranty. Do not use the AC
adaptor with any other product.
– Make certain that the input voltage on the adaptor matches the voltage and frequency
in your location.
– Make certain that the adaptor has prongs compatible with your outlets.
– AC adaptors are designed for indoor use only. Avoid using the AC adaptor in wet
outdoor areas.
– Unplug the AC adaptor from power when not in use.
– Do not short the output connector.
– There are no user-serviceable parts in this product.
– Should damage to the AC adaptor occur, replace it with a new Trimble AC adaptor.
Inserting the battery
To insert the battery into the handheld:
1. On the back of the handheld, use your thumb to press the gray button below the
Microsoft Windows logo and then slide the back cover down to remove it.
2. To insert the battery, angle the bottom of the battery into the handheld, with the
label facing upwards (as shown in
Figure 2.5 ). Press the battery flat until it clicks
into place.
Figure 2.5 Inserting the battery
3. To replace the back cover, slide it upwards until it snaps closed.
B
Tip – To remove the battery, remove the back cover of the handheld and then insert your
finger or the stylus in the notch above the top right corner of the battery. Then pull the
top of the battery towards you.