Therma-Tru Hinged Patio Door System Single Panel Assembly Unit - Manual (Page 10)

FRAME ASSEMBLY - continued
7
Outswing Sill Option
Partially Set Sill Screws
in Jambs
Drive (1) #8 x 2” flat head
screw through holes in both
side jambs until tips barely
protrude through jamb face.
Caulk Entire Sill Gain
Apply a 1/4” bead of sealant
to sill gain and a bead that
matches upper profile of sill.
Fasten Sill to Jamb
Use screw points and index sill in place.
Drive screws using bit sized properly for
screw head.
Pre-drill (2) 3/32” dia. pilot holes through
each jamb into sill substrate.
Drive (2) #8 x 2” flat head screws through
each side jamb into sill substrate in locations
approximately as shown.
Flat head screw
#8 x 2”
Sealant
9