Therma-Tru Hinged Patio Door System Single Panel Assembly Unit - Manual (Page 8)

ATTACH HINGES TO JAMB
6
Fasten Hinges to Hinge Jamb
Place hinges into hinge mortise.
Pre-drill 1/8” dia. pilot holes through
jamb.
Fasten top hinge with (2) #10 x 3/4”
flat head screws in hole locations
shown.
Fasten middle and bottom hinges
each with (3) #10 x 3/4” flat head
screws leaving top hole vacant.
Standard Hinge Option
NOTE:
These are instructions for installation of standard hinges. Proceed to
step 7, FRAME ASSEMBLY, if using adjustable hinges.
CAUTION:
Do not over torque
screws.
#10 x 3/4"
flat head
screws
#10 x 3/4”
Leave Holes Vacant
7