Therma-Tru Hinged Patio Door System Single Panel Assembly Unit - Manual (Page 4)

1
2
REMOVE COMPONENTS FROM PACKAGING
ATTACH HINGES TO DOOR
NOTE:
Product that is purchased with the multi-point lock system will have additional
instructions in the handle hardware box.
Installation instructions will be included in the site package.
NOTE:
A large work area is needed to assemble the frame kit. Cover area with
cardboard from one or more door panel cartons to protect frame parts
and floor. If available
.
a carpeted table can be used to avoid marring
prefinished surfaces
2-knuckle
door leaf
with tabs 3-knuckle
jamb leaf
Use Correct Hinge Leaf
Leaves applied to door have 2 knuckles.
Leaves applied to jamb have 3 knuckles.
Standard Hinge Option
Align and Install Hinges
Place tabs firmly against door.
Fasten 2-knuckle hinge leaves
with #10 x 3/4” flat head screws.
Place hinge
tabs firmly
against door.
Rotate to
opposite
side for
left-hand
application
Right-hand
application
shown
Non-removable
Pin Hinge
NOTE:
Outswing packages come with a
non-removable pin (NRP) hinge.
It is recommended to attach the
hinge in the middle location. For
8’ heights, two NRP hinges are in-
cluded. NRP hinges have locating
tabs. Fasten to door panel using
same method as for unassembled
hinges, placing tabs against door
face to locate hinge.
#10 x 3/4”
3