Therma-Tru Hinged Patio Door System Single Panel Assembly Unit - Manual (Page 7)

INSTALL STRIKES
5
Fasten Security Strike
Assembly to Lock Jamb
Fasten with (2) #9 x 3/4" flat head
screws or (2) 16 gauge 1/2" x 7/16"
crown staples (not supplied) through
strike plate on back side of jamb.
NOTE:
Do not staple through screw holes
when using staples in place of
screws.
Fasten Strike Plates to Lock Jamb
Fit strike plates into mortises on lock jamb.
Pre-drill 3/32” dia. pilot holes through jamb.
Fasten with (7) #8 x 5/8” flat head screws.
Multi-point Lock Option
Standard Strike Option - Inswing
Lock
jamb
(2) #9 x 3/4” flat
head screws
or
(2) 16 gauge
1/2” x 7/16”
crown staples
Adjustable
security
backing
plate
Slide Strike Assembly onto Lock Jamb
Lightly bend tongue area of backing plate
inward to allow for a snug fit then slide
over edge of lock jamb into mortise.
NOTE:
Outswing units will have strike
installed during unit installation.
CAUTION:
Do not over torque screws.
(7) #8 x 5/8”
flat head
screws
#8 x 5/8”
6