Therma-Tru Hinged Patio Door System Single Panel Assembly Unit - Manual (Page 5)

2
3
ATTACH HINGES TO DOOR - continued
INSTALL DOOR BOTTOM
Adjustable Hinge Option
#8 x 1-1/4”
Attach hinge to door
Locate the “H” and “V” markings on hinges.
The two “H” hinges go in top and bottom
locations with the “V” hinge in the center.
For 8’, the “V” hinge is located second from
top of door.
Insert thick side of hinge into pocket in door
and fasten with #8 x 1-1/4” flat head screws.
Sealant
Interior
side
of
door
NOTE:
Outswing units do not
require door bottoms.
Caulk and Fasten Door Bottom
Select a sealant that provides excellent
adhesion to both plastic and wood.
Apply sealant as shown to ends of
door bottom.
Center door bottom and press into
rail kerfs.
Secure each end of door bottom with
(1) #8 x 3/4” wafer head screw.
#8 x 3/4”
wafer head
NOTE:
Inswing hinges are reversible by
removal of hinge pin. Outswing
hinges are reversible by removal
of set screw then removal of
hinge pin.
“H” marked hinge shown
Marking
4