Tascam D00851300A - Manual (Page 12)

12
— TASCAM CD-BT1MKII
Making connections
Connecting a bass guitar (BASS
IN)
BASS GUITAR
 Connect a bass guitar to the BASS
IN jack.
 Set the BASS IN switch to either
PASSIVE or ACTIVE at the side of
the unit according to the type of
your bass guitar.
 The BASS IN jack of the CD-
BT1MKII accepts unbalanced
input signals. Use a ¼ inch mono
phone plug.
Adjusting the input level
Use the INPUT control to adjust the
level of the input signal from the BASS
IN jack.
Inputting signals from external
devices (
LINE IN )
 The LINE IN jack accepts a stereo
mini-jack plug (3.5mm).
 The input level at the LINE IN jack
cannot be adjusted on the CD-
BT1MKII, so adjust the output
level on the external device you
have connected.
LINE OUT OF EXTERNAL DEVICE
WARNING
NEVER connect a bass guitar amplifier to the
CD-BT1MKII’s
BASS IN jack, as you will
damage your equipment if you do this.
Adjusting the output level after
adding built-in effects
Press and hold down the EFFECT/
EDIT key to open the Effect menu, and
press the NEXT or PREV key to choose
LVL and use the UP and DOWN keys to
set the output level between 0 and 64.
Adjusting mix balance between
bass guitar and CD
Press and hold down the TUNER/
SETUP key to open the Setup menu,
and press either the NEXT or PREV key
to choose MIX . You can set the mix bal-
ance using values between B (Bass) 10
– B1, 0, C (CD) 1 – C10.