Tascam D00851300A - Manual (Page 18)

18
— TASCAM CD-BT1MKII
(continued from the previous page)
CAUTION
If you set the key control to O 6 while the fine
tuning value is greater than 0, the fine tuning
value is automatically reset to 0. Similarly, if
you set the key control to
I 6 while the fine
tuning value is less than 0, the fine tuning
value is automatically reset to 0.
Also note that when key control or VSA is
ON, you may find that the music played back
has a “vibrato” feel. This is not a fault of the
CD player – it is a natural result of the special
effects.
Using CD effects
Turning CD effects on and off
Pressing the CD EFF switch at the side
of the CD-BT1MKII turns on the pre-
set CD effects: guitar cancel, mono
monitor, split monitor. These three CD
effect components can be used simulta-
neously. The CD EFF symbol is shown on
the display. Press the CD EFF switch
again to turn off the CD effects.
BEE (Bass Enhancement Effect)
BEE reduces or enhances the bass com-
ponent of the CD playback.
Press and hold the TMP/KEY / CD EFF
key to enter the CD Effect menu. Press
either the PREV or NEXT key to choose
BEE . Press either the UP or DOWN key
to select from the choices listed below:

OFF : normal playback (the sound is
not affected in any way)
 BST : the bass component of the
sound will be boosted
 ENH : the bass component of the
sound will be boosted and the
definition of the bass part of the
music will be enhanced
 CUT : bass component of the sound
will be cut out
Mono monitor
Setting the monitor mode allows you
to control the output signal between
mono and stereo with alternate options
for both.
Press and hold the
TMP/KEY / CD
EFF key to enter the CD Effect menu,
and select MONO by pressing either the
PREV or NEXT key. Press either the
UP or DOWN key to select from the
following:
 L+R : outputs a mono signal, mix-
ing the L (left) and R (right) chan-
nels.
 L : outputs the L channel signal
only.
 R : outputs the R channel signal
only.
 OFF : outputs normal stereo signal.
Split monitor
Setting the split monitor mode allows
you to split the CD output and the bass
guitar into left and right outputs.
Press and hold the
TMP/KEY / CD EFF
key to enter the CD Effect menu, and
select SPLT by pressing either the PREV
or NEXT key. Press the UP or DOWN
key to select from the following:

C-B : outputs the sound of the CD
from the left, and the sound of the
bass guitar from the right.
 B-C : outputs the sound of the bass
guitar from the left, and the CD
sound from the right.
 OFF : outputs stereo mixed sound of
CD and bass guitar from left and
right.
Using CD effects