Using built-in effects (continued) – Tascam D00851300A User Manual
Page 20
20
— TASCAM CD-BT1MKII
(continued from the previous page)
nents can be adjusted by press-
ing either the
UP
or
DOWN
key.
Components shown in bold in the
Effect Library Chart are mixable.
In the example of “compressor 5,“
the
WAH
and
DLY
components are
followed by their own mix pa-
rameters in the display, with
MIX1
following
WAH
and
MIX2
following
DLY
. Use either the
UP
and
DOWN
keys to mix the
WAH
and
DLY
com-
ponents in this effect.
DLY
is always
mixed using
MIX2.
8. Continue selecting the compo-
nents to edit by pressing either the
PREV
or
NEXT
key. Select values
for the components by pressing ei-
ther the
UP
or
DOWN
key.
9. The last parameter of the sequence
for each library effect preset is
LVL
(the output level from the effect
unit). Set the output level from 0
to 64 by pressing either the
UP
or
DOWN
key. Note that the output
level is only available when the ef-
fect is turned on and is bypassed
when the effect is off.
10. Press the
TIME/ESC
key to exit
the effect settings. The effect set-
tings you have made are automati-
cally stored in the effect slot you
first chose in steps 1 and 2.
Adjusting the mix
You can adjust the mix level of the
effects of the components shown in
bold in the Effect Library Chart. In
MIX1
mode the components
FLA
,
CHO
,
WAH
,
OCT
and
TECH
can be mixed. In
MIX2
mode the component
DLY
can be
mixed.
Recalling an effect with your
settings
When you have stored the effect set-
tings in an effect slot as described
above, you can recall them simply by
pressing the
EFFECT/EDIT
key to se-
lect the appropriate effect slot.
TIP
If you have connected a footswitch such as
TASCAM RC-30P (sold separately), you can
step through the bank slots by pressing the
footswitch. Make sure that FOOT in the Setup
menu is set to either FX+ or FX-.
EFFECT LIBRARY CHART
1 DLY
2 FLA-DLY
3 CHO-DLY
4 WAH-DLY
c1 COMPL-COMPH
c2 COMPL-COMPH-DLY
c3 COMPL-COMPH-FLA-DLY
c4 COMPL-COMPH-CHO-DLY
c5 COMPL-COMPH-WAH-DLY
c6 COMPL-COMPH-OCT-DLY
c7 COMPL-COMPH-TECH-DLY
d1 DIST-HCUT
d2 DIST-HCUT-DLY
d3 DIST-HCUT-FLA-DLY
d4 DIST-HCUT-CHO-DLY
d5 DIST-HCUT-WAH-DLY
Using built-in effects (Continued)