Tandberg Data NAS Hardware Viking FS-1500 - Manual (Page 106)

Tandberg Data Distributed File System
__________________________________________________________________________________________________
7-16 Tandberg Viking Series Storage Server Administration Manual
To enable DFS Replication on the Tools folder:
1. In the console tree of the DFS Management snap-in, right-click the
Tools folder, and then click Replicate Folder.
2. Follow the steps in the Replicate Folder Wizard and supply the
information in the following fields:
o
Replication Group and Replicated Folder Name - Accept
the defaults.
o
Replication Eligibility - Accept the defaults.
o
Primary Member - If the folder targets are empty, choose
either member. If both folder targets contain content, choose
the member that has the most up-to-date content.
o
Topology Selection - Select Full mesh.
o
Replication Group Schedule and Bandwidth - Select
Replicate continuously using the specified bandwidth.
o
Review Settings and Create Replication Group - Click
Create to create the replication group.
o
Confirmation - Click Close to close the wizard.
o
Replication Delay - Click OK to close the dialog box that
warns you about the delay in initial replication.
After you finish the previous procedure, navigate to the Replication node in
the console tree. Notice that a new replication group has been created, as
shown in the following figure.
If you are not familiar with DFS Replication terminology, a replication group
is a set of servers, known as members, that participates in the replication of
one or more replicated folders. A replicated folder is a folder that is kept
synchronized on each member. When you enable DFS Replication on a
folder with targets, the servers that host the folder targets become members
of the replication group, and the folder targets are associated with the
replicated folder. The name of the replication group matches the namespace
path (Contoso.com\Public\Software\Tools), and the name of the replicated
folder matches the folder name (Tools).