Tandberg Data NAS Hardware Viking FS-1500 - Manual (Page 115)

Tandberg Data Distributed File System
__________________________________________________________________________________________________
7-25 Tandberg Viking Series Storage Server Administration Manual
7.6.3. Share and Publish Replicated Folders in a
Namespace
When you created replicated folders in the previous tasks, you specified the
local path of a folder on each member of the replication group. Unless the
local path on each server was previously shared, users cannot access the
replicated folders after they are created. To make replicated folders available
to users, you must share them and, optionally, publish them in an existing
namespace.
In this task, you publish the LOB Data replicated folder in the
\\server_or_domain\Public namespace that you created in the DFS
Namespaces step-by-step section. If you did not complete the previous step-
by-step section or do not have a namespace in your test lab, skip this
procedure.
To share the LOB Data replicated folder and publish it in a namespace:
1. In the console tree of the DFS Management snap-in, under the
Replication node, click the Data Distribution replication group.
2. In the details pane, click the Replicated Folders tab, right-click the
LOB Data replicated folder, and then click Share and Publish in
Namespace.
3. Follow the steps in the Share and Publish Replicated Folder
Wizard and supply the information in the following fields.
o
Publishing Method - Select Share and publish the
replicated folder in a namespace.
o
Share Replicated Folders - For each member that shows
[Shared Folder Needed] in the Action column, select the
member, and then click Edit to create the new shared folder
and adjust shared folder permissions if necessary. If the
Action column shows Create shared folder: LOB Data or
Existing Shared Folder, you can click Next.
o
Namespace Path - In Parent folder in namespace, type
\\server_or_domain\Public\Software.
o
Review Settings and Share Replicated Folder - Click
Share to share the replicated folders and publish the LOB
Data replicated folder in the namespace.
o
Confirmation - Click Close to close the wizard.
After you finish the wizard, review the console tree and the Replicated
Folders tab in the details pane. First, notice in the console tree that an LOB
Data folder was added to the namespace and the folder icon indicates that
the folder is replicated, as shown in the following figure.