Tiger Mowers SIDE FLAIL ASEMBLIES JD 5085M-105M - Manual (Page 104)

MAINTENANCE
Side and Rear Flail Maintenance Section 4-16
©2012 Alamo Group Inc.
MAINTENANCE
GREASING CUTTER SHAFT-FLAIL MOWERS
Locate grease zerks on each end of cutter shaft(s).
These are located on the bearing cover. Normal
conditions require one or two pumps in each
bearing, using Lithium-Complex Extreme Pressure
grease conforming to NLGI2-ISO 320
specifications. This is to be done with a standard
grease gun daily or at
8 hour intervals. CAUTION:
Over greasing may cause premature seal
failure.
GREASING GROUND ROLLER SHAFT-FLAIL
Locate grease zerks on each end of roller tube at
lower rear of head. Normal conditions require one
or two pumps in each bearing, using Lithium-
Complex Extreme Pressure grease conforming to
NLGI2-ISO 320 specifications. This is to be done
with a standard grease gun daily or at
8 hours
intervals. CAUTION: Over greasing may cause
premature seal failure.
GREASING THE IDLER TENSION ARMS
Locate the access holes and grease zerks in the belt shields of the side and rear flails. Normal conditions
require one pump daily or every 8 hours of service with multi purpose grease.