Tiger Mowers SIDE FLAIL ASEMBLIES JD 5085M-105M - Manual (Page 74)

OPERATION
Side and Rear Flail Operation Section 3-22
© 2012 Alamo Group Inc.
OPERA
TION
Using the tractor 3-point hitch control lever, raise
the mower off the ground about 6”, or just high
enough to clear any ground obstacles. When
raising the mower, make sure all connection points
are securely attached and at least 1” clearance is
maintained between the driveline and the deck. If
necessary, place an upper lift strip on the 3-point
hitch control lever to limit the height the mower can
be raised to avoid driveline damage.
9.3 Driving the Tractor and Implements
Start off driving at a slow speed and gradually
increase your speed while maintaining complete
control of the tractor and units. Moving slowly at
first will also prevent the tractor from rearing up
and loss of steering control. The tractor should
never be operated at speeds that cannot be
safely handled or which will prevent the operator
from stopping quickly during an emergency. If the
power steering or engine ceases operating, stop
the tractor immediately as the tractor will be
difficult to control.
Drive the tractor with the 3-Point lift arms in the
raised position and lock the control lever in the
transport detent position to prevent damage to
the mower driveline when turning.
Perform turns with the tractor and units at slow
speeds to determine how the tractor with an
attached mower handles a turn. Determine the
safe speed to maintain proper control of the
tractor when making turns.
To avoid overturns, drive the tractor with care and
at safe speeds, especially when operating over
rough ground, crossing ditches or slopes, and
turning corners. Tractor wheel tread spacing
should be increased when working on inclines or
rough ground to reduce the possibility of tipping.
Use extreme caution when operating on steep