Tiger Mowers SIDE FLAIL ASEMBLIES JD 5085M-105M - Manual (Page 36)

ASSEMBLY
Assembly Section 2-10
PRESSURE LINE INSTALLATION
The hydraulic pressure line will be plumbed into the tractors power beyond port. Locate the
power beyond port on the upper right side of the tractor rear remotes, remove the plug (refer to
the illustration below and the Parts Section). After the plug is removed, connect the adapter and
route the hose from the adapter to the lift valve, as shown in the Parts Section.
(ASM-JD-0089)
RETURN LINE INSTALLATION
The return line will be plumbed into the front of the Branch Tee, as shown in previous illustra-
tion, which will be assembled into the adapter located below the tractors’ power beyond port.
Remove the elbow or plug from the rear remotes and replace it with the supplied Branch Tee.
Connect the line from the Mid-mount valve to the Branch Tee. If your tractor does not have a
Mid-mount valve, then install the supplied cap on the back side of the Branch Tee. Plumb the
return line from the front ot the Branch Tee to the adapter on the lift valve.
(ASM-JD-0090)