Tiger Mowers SIDE FLAIL ASEMBLIES JD 5085M-105M - Manual (Page 42)

ASSEMBLY
Assembly Section 2-16
TEMPERATURE GAUGE MOUNTING
(OPTIONAL)
Mount the temperature gauge where it is clearly visible to the operator. Attach the green (-)
wire from the negative post on the gauge to a grounded bolt on the tractor frame. Remove paint
if needed to make a good ground. Remove the pipe plug from the side of the hydraulic reservoir
and install the temperature sensor using thread sealing tape. Run the white wire from the (s)
sensor post of the gauge to the temperature sensor on the hydraulic reservoir tank.
(ASM-C-0051)
MAIN FRAME INSTALLATION
With an overhead hoist and / or jack-stands, raise one side of the frame up to the correctly
matching mounting holes. Install capscrews and all other hardware as shown in main frame
parts section to secure the sides of the main frame to the tractor casting, DO NOT tighten at this
time. Remove the capscrews one at a time and apply a thread locking agent. Reinsert the
capscrews and tighten / torque to values noted in the torque chart located in the maintenance
section of this manual.
(ASM-C-0003)
AXLE BRACE MOUNTING
Position the right axle brace under the tractor right hand side. Raise the brace up to the
matching mounting holes in the main fame and rear axle housing. Note the right side brace is
installed on outside edge of the main frame and the left side brace is installed on the inside edge
of the main frame. Pictures below show right side brace installation. Install the clamp plate with
capscrews, washers and nuts as shown in the main frame parts section. Apply Loc-Tite to the
threads and torque to the values noted in the torque chart located in the maintenance section of
this manual.
(ASM-JD-0072)
.